EPROM Emulator 2716-27512 for Z80, 6502, 8080, 6802, Commodore, Atari, 8bit SBC

Description

This EPROM emulator can be used when writing code for older 8 bit computers, like the Commodore, Atari, Tandy and similar. It will be handy when doing experiments with old Z80 or 8051 microprocessors/microcontrollers that don't support flash memory and are using EPROMs instead.
The device is open-source, and all design details can be found on https://mygeekyhobby.com page. Comes fully assembled, tested and fully working. It will come with DIP28 emulator probe that supports
2764-27512
EPROM memory
(note: it is possible to also support 24 pin devices like
2716 or 2732
by keeping the top 4 pins of the 28pin emulator probe unplugged, power would have to be provided by the USB cable).
There is now an experimental firmware version that brings support for the popular EEPROM memory (28C64 and 28C256), I have reports from users successfully emulating 28C256 on Ben Eater BE6502 SBC and others similar systems that use EEPROM.
What is included in the purchase:
* Professionally soldered and tested EPROM EMULATOR NG device (
HW v2.2c or 1.9c depending on stock
)
* DIP28 Emulator cable (Colors/design of the cable and reset hooks might be different from what is pictured)
* Software and firmware is open source can be found on the product website.
Firmware for the device is provided as Arduino sketch, control software running on your computer is written in python (tested on Windows, macOS and linux)
Please note:
the color of the 3d printed "base plate" for the device will
vary depending on the material I have available at the time. I will ship either hw 1.9c or 2.2c depending on stock (both have same functionality, just use different SRAM chips).
Here is an overview of the device:
https://www.youtube.com/watch?v=R-7MnERB6b0&t=10s
Check out also a cheap Z80 "test target" I built:
https://www.ebay.com/itm/174538282856
Will ship USPS in USA (if your location in USA is outside of normal USPS service please reach out to me for updated postage fees before you check out)
Shipping from USA To Europe/UK via is expensive so I use eBay International Standard Delivery, keep in mind the import duties and other relevant taxes are outside of my control and are buyer's responsibilities.
Legal Notice:
The device is intended for use for
ENGINEERING DEVELOPMENT, DEMONSTRATION OR EVALUATION PURPOSES ONLY and is not considered to be a finished end-product fit for general consumer use. Persons handling the product must have electronics training and observe good engineering practice standards. As such the goods being provided are not intended to be complete in terms of required design-, marketing-, and/or manufacturing related protective considerations, including product safety and environmental measures typically found in the products that incorporate semiconductor components or circuit boards.
The user assumes all responsibility and liability for proper and safe handling of the device. Further the user indemnifies me from all claims arising from the handling or use of the device. Due to the open construction of the product, it's the user responsibility to take any and all appropriate precautions with regard to electrostatic discharge, conducted and radiated emissions.
The device likely generates, uses, and can radiate radio frequency energy and has not been tested for compliance with the limits of computing devices pursuant to part 15 of FCC rules, which are designed to provide reasonable protection against radio frequency interference. Operation of this equipment in other environments may cause interference with radio communications, in which case the user at his own expense will be required to take whatever measures may be required to correct this interference.
EXCEPT TO THE EXTENT OF THE INDEMNITY SET FORTH ABOVE NEITHER PARTY SHALL BE LIABLE TO THE OTHER FOR ANY INDIRECT SPECIAL INCIDENTAL OR CONSEQUENTIAL DAMAGES.